PART CHANGING:
Feed disc and gravure rolls
need to be changed to suit the shape and size of the product.
Feed discs can be ordered with different numbers and sizes
of pocket and can be interchanged in 5 minutes. Gravure
rolls can also be ordered with any imprint and these are
matched with the pocket spacing on the feed disc. Roll changing
requires just one minute.
CAPSULE & TABLET SIZES: Tablets
3.175 to 12.7mm diameter. Capsules size 00 to 5 upto 25.4
mm long.
POWER & AIR REQUIREMENT:
Power Supply - 230 volts single phase and 440 volts 3 phase.
Compressed air requirement 4 cfm at 40 Psi
PRODUCTION RATES:
(Dependent on diameter or length of item)
|
Length not
exceeding
|
Estimated
production per hour
|
| 5.556 mm |
90,000 To 120,000
|
| 10.319 mm |
70,000 To 95,000
|
| 17.463 mm |
45,000 To 60,000 |
| 25.400 mm |
35,000 To 48,000 |
OPERATION: Operation
is completely automatic. After initial set-up, operator
has to only replenish tablets or capsules and ink reservoir,
when required. It automatically feeds, positions, meters,
imprints and ejects. Operation is controlled by a toggle
switch and a foot pedal.
FEED DISCS AND GRAVURE ROLLS:
Feed discs and gravure rolls can be ordered in any size
in order to obtain most efficient production. Discs are
available in 45 pockets. The smaller the piece, the more
pockets can be used and the higher the production rate.
Number of pockets on the feed disc determines spacing of
the imprints etched on the gravure roll-each disc requires
a matching roll. However, both discs and rolls are moderately
priced and quickly changed. One machine equipped with several
feed discs and gravure rolls is a fully flexible printer
able to mark almost any tablet or capsule the manufacturer
may wish to market.
PRINTS ON ANY SHAPE:
Prints on almost any size or shape, on one side or both,
in one colour or two of either empty or filled capsules.
